The front tie-down kit was designed specifically for the 1st Generation BX tractors. If you are constantly trailering your tractor, this is a great alternative to chaining your vehicle down in ways that could scratch or scrape your paint. It ties easily into the motor mount bolt just under the front grill, and is in the perfect spot for securing the front of the tractor from either side.The tie downs are built out of a .25” A35 plate and are welded together creating an LH and RH mount. These tie downs fit all of 1500, 1800, and 2200 Gen 1 BX-Series tractors. It ties into the hood pivot mount bolts under the front side shield of the motor and comes with an extra set of grade 10.9 flange bolts to replace the factory flange bolts. The front ties down mounts are positioned for optimal securement for the front of the tractor.
When used in conjunction with the Rear Receiver Hitch (RS-BXRH
) it allows for 4 point load security as required by the DOT.
- Constructed from .25" A36 Steel plate
- 2" Width
- Simple Bolt On Design Utilizes the Motor Mount Bolts and Nuts
- Powder Coated Finish
- Made in USA
Note: Will not work on models with drive over mower decks.