Tractor Cab Enclosure for Kubota BX Series Tractor - Requires E1133 Canopy

Easy Assembly Tractor Cab Enclosure installation steps:

1. Put roof top cover on over fiberglass roof  - label sew in back of the cover
2. Zip panels onto roof top zippers and slide doors into slide rail then zip together panels allow them to hang for a couple of hours
3. Connect strap under tractor and pull tight make sure it is not rubbing against something hot where it might burn through the webbing. Cut off any excess webbing and burn the edge with a lighter so it doesn't have the ability to continue to unravel.
4. Bend over tabs around fenders and body at all tab locations, stretch the elastic hooks and connect them at the fenders, floor board and around the rear areas near seat making sure that all fabric is out of the way of any implements that may be attached. 
5. Connect front rear and side hooks through grommets (attached to the elastic straps) and install as necessary as defined in step above.